How to operate stone engraving machine, stone engraving machine use process, apprentices to operate the stone engraving machine accurate steps, this article belongs to the engraving machine tutorial. Generally speaking, the process of using the stone engraving machine will be discussed, and then a more detailed tutorial will be updated.
Making the engraving path - simulating the engraving path to ensure the correct path - checking the machine is ready before machining - placing and fixing the sheet - determining the origin of the workpiece - starting the machining - processing is completed
First, making the engraving path
According to the customer's needs, the corresponding engraving path is made. The first kind of self-made map making engraving path; the second kind is to find a professional drawing person to make a path; the third kind of scanner to dot the instrument making path
Second, the simulation engraving path ensures that the path is correct
This is a very safe way. Sometimes the engraving path is incorrect due to a small error. At this time, the engraving path is simulated to determine the engraving path is correct and the processing error rate is reduced.
Third, preparation before processing
Check if the machine table is clean, at least no debris affects the board placement. The Pesen stone engraving machine has a no-clean table. See if the sludge in the sedimentation tank needs to be cleaned.
Look at the machine head cooling water tank, the spindle cooling water source is sufficient, whether you need to change the water.
Look at the power cords are connected, whether each power plug and the plug is connected, the Payson stone engraving machine does not need too many plugs, no clear line configuration, so you can save your effort and greatly reduce the operating error rate.
Close the tool chuck to avoid accidents caused by the looseness of the tool during the engraving process.
Look at whether the water cooling of the main shaft has been supplied to the water. When the Pesen stone engraving machine is turned on, the main shaft cooling water is automatically turned on, which reduces the phenomenon that the main shaft of the machine is damaged due to forgetting to open the cooling water.
Move the machine engraving head to the appropriate height and position, and facilitate the next step of placing the plate.
Fourth, placing plates and fixing plates
Generally, the plate is fixed at the position of the upper left corner, that is, the position of the mechanical origin, and then the stone is fixed by the pressure plate.
Fifth, determine the origin of the workpiece
Loading the engraving path and determining the origin of the workpiece is to unify the point on the stone and the origin in the path for further processing. The origin of the workpiece is different from the mechanical origin, so be careful when handling the newbie.
Sixth, start automatic processing
At this time, according to the hardness of the stone and the condition of the machine, set the running speed for automatic processing. In the middle, just pay attention to whether the cooling water of the spindle is overheated. You can equip yourself with a larger water tank, so that basically no problem; then Just look at the wear of the machine tool, and listen to the sound to hear the tool wear.
Seven, processing is completed
Many customers are eager to disassemble the sheet after processing, which is not so good. You should first look at the engraving effect, whether all the processing steps are completed, and move the engraving head to the place where the sheet is easily removed.
