There are many reasons why the engraving machine is not engraved in size, for example
1. The engraving size of the advertising engraving machine caused by the wrong path setting of the software is incorrect.
2. The gap size of the screw and the loosening of the fastening screw of the polished rod may cause the engraving size of the advertising engraving machine to be incorrect.
3. The software parameter setting error caused the engraving size of the advertising engraving machine to be incorrect.
4. The engraving size of the advertising engraving machine caused by the ground wire is not connected properly.
5, the computer engraving machine engraving machine engraving size is wrong.
What should I do if the engraving machine is not engraved?
1. The path of the advertisement engraving machine software is set incorrectly, and the path is modified.
2. Check the gap size of the screw and the tightening screw of the polished rod. If it is loose, tighten it.
3. Check the software parameter settings. If it is wrong, correct it.
4. If the ground wire is connected well, it will be connected if it is not connected.
5, check whether it is caused by a computer virus, if it is, then kill the virus.
Is the size of the engraving machine not correct? The engraving machine engraving size is too small, it may be a programming problem, if the shape has not changed, it is a problem of programming or operation. The size of the advertising engraving machine is too large, which may be a problem of tool wear. Then what should I do if the size of the advertising engraving machine is not suitable?
1. If the size of the machined part is too large, it will be biased. For example, when machining 70mm, it will get a value close to 70mm. However, if the machining part is too small, for example, processing 15mm, the size will be larger, 15.1mm.
2, processing holes, small size is particularly obvious, the aperture is smaller than the actual value (I don't know if it is caused by the caliper caliper error), but with the same nominal value of the bit handle into the hole, obviously feel the hole is small, put If you don't go in, for example, you need to put a 3.2mm drill bit. It is necessary to process a 3.4mm hole to put it in.
In the above experiment, I used a 1mm PCB milling cutter. I found that some phenomena are quite similar to the actual size of the tool. However, I think that the tool size is not likely to be correct, and the amount is measured by the ruler, which is basically 1mm. (The accuracy of the ruler is not very good), and the size is still accurate when processing large parts.
Dema advertising engraving machine engraving size?
The engraving size of the M2 advertising engraving machine is 1300*2500*80mm.
The engraving size of the M5 advertising engraving machine is 1300*2500*80mm.
If you want to know other performance parameters of Dema advertising engraving machine, you can contact us directly.
